A640 Driver

• 

  K'Kan Korakot

  • September 07, 2019 05:25

  How to adjust the area ?

   

   

  0

  Comment actions Permalink
• 

  Parblo Support

  • September 09, 2019 02:15

  Hi, K'Kan Korakot

  
  Please refer the below picture to adjust the area.

  You can also contact us via email to cs@parblo.com if there were any question. Thanks.

   

  

  0

  Comment actions Permalink
• 

  Varishax777

  • September 25, 2019 16:05

  when will the pressure be available? 

  3

  Comment actions Permalink
• 

  kelly

  • October 11, 2019 12:52

  Can't get this to work with MacOS Catalina 10.15 it plugs in but wont recognize any input on the tablet nor pressure sensitivity or anything else. It won't even work as a mouse. Please update the driver.

  5

  Comment actions Permalink
• 

  ItsAceXD

  • November 02, 2019 01:43

  I can't seem to get my stabilizer to work on anything! (Medibang, Fire alpaca, Paint.Sai) Only krita and photoshop work, and both in my opinion have terrible functions for drawing soooo- h e l p.

  1

  Comment actions Permalink
• 

  Mathwendyjo

  • September 13, 2020 13:03

  It says the driver was updated to work on Catalina, but the link takes you to the driver for Ninos.  Please fix the link.

  1

  Comment actions Permalink
• 

  Edgar

  • February 01, 2021 04:23

  It is very jittery when you move slowly is there any fix? I heard the old drivers are better but there are no links for it for mac.

  1

  Comment actions Permalink
• 

  Gleb Bondarenko

  • February 06, 2021 12:59

  Both Hotkeys `Pen` and `Brush` are sending the same a symbol `B`, but `Pen` should send `P`

  -1

  Comment actions Permalink
• 

  Annie Gabrielle

  • April 08, 2021 18:52

  've bought a Parblo A640 and since the installation I've been bothered for some bugs on using. The tablet is connecting ans disconnecting all the time. The ParbloTableSetting says often (like every 5 seconds) the message "device not found".

  I have a Catalina 10.15.

  0

  Comment actions Permalink
• 

  Eninaej

  • June 14, 2021 13:33

  Hi, I already installed the driver, but I get this message every time I try to open the digitizer panel program. It is connected, and it works, but I do not have the function of the hot keys, the digitizing tablet only serves as a mouse, and does not have the special functions.
  I would settle for this, but I would like to use it with the full functions

  0

  Comment actions Permalink

Please sign in to leave a comment.