How to solve the problem of the Parblo Ninos Neo/Intangbo SW/Parblo Ninos Q being connected to an Android device, where the digital board can only be used in the left one-third area (turning circles into ellipses)?

Please note that:
Before connecting, be sure to adjust the gear of the Parblo Intangbo SW product to [phone] mode (please click on the gear adjustment tutorial)
Before connecting, make sure to adjust the gear of Ninos Neo to [phone] mode

Before setting, Ninos Q be sure to move the digital board swivel to the "custom" position. After setting, connect this phone and keep it in the custom position for use
1. Click here to download and install the "Parblo Pablo" software.
2. Connect the digital board, open the Parblo software to customize the scale setting, select "Adapt to 1/3 area abnormality", and then click "OK".

3. After setting up, reconnect the digital board to use it normally.

Special note: If the Paibaoluo APP does not recognize Ninos Q, you need to upgrade the firmware first and then set the one-third ratio.
Video tutorial click here